HDG hot dip galvanizing furnace for fasteners , screws Design output about 1.5ton/hour
1.Production line requirement
1. Hot-dip galvanized products: small pieces such as fasteners;
2. Galvanizing method: manual galvanizing;
3.HDG furnace galvanizing temperature range: 430～650℃ (adjustable);
4. Effective size of galvanized kettle: 2×1×1.2m (length×width×depth)
5. Design output: about 1.5ton/hour;
6.Heating energy: electric heating+resistance rods;
7.Heating power for zinc ceramic kettle:240kw;
8.Power for centrifugal zinc recycling device:7.5kw;
9.Rotation speed of centrifugal basket: 750RPM;
2.Equipment overview
2.1zinc kettle
According to the workpiece size and production requirements, the size of the zinc kettle would be : 2×1×1.2m(length×width×depth).
The ceramic zinc kettle is once-forming by high-temperature resistant castable.
| Item |
High-temperature ceramic zinc kettle |
Traditional iron
zinc kettle
|
| Zinc slag |
High temperature zinc liquid does not react with the kettle |
High temperature liquid zinc reacts violently with the pot |
| Heat conversion efficiency |
≈95% |
≈75 % |
| Insulation coefficient |
0.88 |
0.78 |
| Service life |
≥ 5 years |
1 ~ 3 months |
| Control method |
adjustable power |
Power not adjustable |
2.2 Hot dip galvanizing furnace: heating rod
The heating equipment adopts the special hot-dip galvanized heating rod made of international advanced
resistance wire material, which has high efficiency and long service life. The heaters are respectively utilized
with SSR modules, and intelligent instruments are used to control the power regulator to achieve continuous
heating power adjustment from zero to full load. This scheme has high control precision, no fault,
maintenance-free, and no pollution to the power grid. Heating rod size:Φ60x850mm, 10kw per piece.
There is a total of 24 heating rods.
2.3Electric control
The intelligent temperature control instrument control system is used to operate. When the medium temperature
is close to the set value, the electric heating control system performs PID calculation according to the
temperature sensor signal of the output port, and automatically adjusts the temperature control system.
To meet the process temperature provided by the hot dip galvanizing heating furnace, the heating temperature
is controlled within ±2 degrees.The hot dip galvanizing furnace adopts intelligent automatic control, with digital
current display, automatic temperature control display, branch heating plate temperature control display, leakage
protection device, temperature control over-temperature alarm device.
2.4centrifugal zinc recycling device
The zinc recycling device uses the centrifugal force to recover zinc. Centrifugal basket size: 400*370mm(dia*height);
motor power: 7.5kw, rotation speed: 750RPM.
3.Zinc pot drawing
4.Post-sales Service
The HDG furnace is warranted for 13 months from the date of shipment. The seller is responsible for repairing the furnace or
replacing the broken parts if faults are caused by manufacture defects, but damages caused by faulty operation by the workers
are to be repaired by the buyer itself or by the seller at a certain rate of charge. (Easy-worn parts, and natural consumption of
high temperature parts are not included in the warranty.)
Product Tags:
|
|
HDG Hot Dip Galvanizing Furnace For Fasteners Screws Design Output About 1.5ton/hour Images
|
